Thinking about replacement windows? Consider Optimum’s Self Closing Sliding Steel Window.

Series SC7600 Optimum's fire rated sliding steel window features a self-closing mechanism that automatically closes the window in the event of fire. This sliding steel window incorporates the same type of fusible link in Optimum's other fire rated products.

SC7600 Series Specifications

Steel horizontal sliding window shall be Series SC7600 as manufactured by Optimum Steel Window Corporation. All windows shall carry either an MEA or Underwriters Laboratories, Inc. (UL) fire resistance rating of 45 minutes in accordance with the fire standards for Fire Tests of Window Assemblies, ANSI/UL9 (NFPA 257, ASTM E163).

Materials: All principal cold rolled formed members shall be ASTM A528 low carbon steel. Frame members shall have a minimum thickness of 20 gauge.

Weatherstripping: Sliding sash panel shall have EPDM gaskets throughout entire perimeter (unless otherwise noted).

Finish: All units shall be reasonably free from scratches and blemishes having the following:

* Zinc coating (ASTM A525 Z200) on both surfaces, applied by a continuous hot dipped process (the Sendzimir system) followed by a "skin pass" (smoothing) procedure, which eliminates roughness.
* Primer consisting of a thermosetting epoxy-ureic paint, applied at a thickness of 5 microns on both surfaces.
* Baked polyester powder coating. (Baked at 180-200° C for 18 to 20 minutes) with an average thickness of 80 microns.

Glazing: Windows shall be factory glazed with obscure or clear 1/4" wire glass. Lites shall have a minimum of 24-gauge wire and a maximum mesh size of one square inch, as per Underwriters Laboratories requirements. Individual lites of glass shall not exceed a day lite dimension of 895 square inches each. Glass shall comply with ANSI Z97.1 and ASTM C1036.

Construction: Frame to be formed of 20 gauge steel sections, with corners which are mechanically assembled and reinforced. Sash members shall be 20 gauge formed sections, which are coped and assembled. Corner joints shall be fully sealed to prevent leakage. Vent sash shall roll on an 18 gauge track with 1/4" diameter steel ball bearing rollers. Horizontal muntins, when required, shall consist of two sections of 20-gauge steel forming an "H" section. Approved 1/4 " wire glass to be held in a 3/4" uniform edge bite.

Hardware: Sliding panel shall be furnished with a white bronze operating handle, which is attached to the jamb of the operable sash. A spring activated automatic closing device is used in conjunction with a 165-degree fusible link assembly mounted on the unit. This assembly functions as a self-closing mechanism.

Installation: The installer shall set all window frames in a level, plumb and square condition without distortion. Units shall be promptly anchored, flashed and caulked in accordance with good window installation practice.

For more information on Optimum's SC7600 Series windows or other models, stop by one of the Window Man's showrooms in Fairfax, Chantilly and shortly in Fairfax, VA.